Blog

About Rock Drill Pantera

Rock Drill Pantera 1500 is a hydraulic, self-propelled, selfcontained, crawler based surface drilling rig equipped with a cabin and a rod changer. It drills 89 – 140 mm (3 ½” – 5 ½”) vertical, inclined or horizontal holes with 51 and 60 mm ( 2” and 2 3/8” ) extension rods or 102 – 152 mm (4” – 6”) vertical, inclined or horizontal holes with 76 and 87 mm (3” and 3 ½”) tubes.

Good results in difficult ground conditions are obtained by using pilot tube drilling, where the first rod is replaced by a 76 or 87 mm (3” or 3 ½”) special tube.

Pantera 1500 is equipped with HL 1500, hydraulic top hammer rock drill. With high rotation torque, proper flushing and sophisticated, ergonomic drilling control system the rig adapts itself easily into varying rock conditions.

The rig has a Telescopic Boom for fast hole spotting and set up of the feed. The cylinder feed for max. 6,1 m (20 ’) starter rod for single pass drilling together with carousel type rod changer with a possibility to use 4,3 m (14 ’) rods add productivity of drilling.

The powerpack of Pantera 1500 consists of Caterpillar diesel engine and a gearbox, which divides the power for hydraulic pumps (two variable displacement pumps) and flushing air compressor. All panel sections can be opened for easy access to service spots.

Powerpack is mounted crosswise at the rear of the rig to balance the weight of the boom and the feed.

Pantera 1500 has an ergonomic and roomy full vision cabin 

to increase operator’s comfort and efficiency. The cabin is certified for F.O.P.S. and R.O.P.S. (Falling Object Protection Structure and Roll-Over Protection Structure). Windows are safety laminated and the noise level in the cabin is less than 80 dB(A). Optimal visibility to the drilling spot is achieved by locating the control levers to both sides of the cabin.

Drilling functions are proportionally controlled by one joystick on right hand side. Rod changer functions are controlled by another joystick on left hand side. Cabin exceeds all standards for operator’s working environment.

Pantera 1500 is designed for EFFICIENT PRODUCTION drilling in large quarries or open pit mines and construction work sites. It suits well also for wall control and development works. To customize the rig it can be equipped with a variety of options to meet special requirements.

STANDARD COMPONENTS

1. Rock drill………HL 1500, hydraulic

2. Feed……………LF 1514

3. Rod changer……..RC 1514

4. Boom……………ZB 1550 H, telescopic

5. Carrier…………FL 6, oscillating

6. Powerpack……….Diesel driven, hydraulic pumps and on board compressor

7. Hydraulic……….system Load sensing and open center

8. Control…………system THC Pro 9. Operator’s………cabin Ergo Pro

10. Dust collection…DC 1520 H, hydraulic system

11. Working lights….8 pcs

12. Gauge set………For accumulator pressure checking

13. Reversing alarm

14. Manuals……….. Service and spare parts manuals:

…………………..2 x paper copy

…………………..2 x CD-ROM (Toolman)

15. EU-safety devices

TRANSPORT DIMENSIONS

Weight………..19 000 kg
Width…………2.52 m
Height………..3.2 m
Total length…..10.5 m

LASTEST UPDATE FROM INSTAGRAM

@exxaquipment